Highlights
The Parametric modelling module (1) eliminates the need to actively adapt the model after changes to the initial design, and (2) enables general optimisation.
Examples of the use of parameters in a model include:
Each parameter has a specific type assigned. For example, only parameters of type length can be assigned to distances. Types make it easier to handle units, especially when ranges must be defined for the valid values of a parameter.
The module makes it possible to also parametrise libraries. As an example, one parameter type in SCIA Engineer is Cross section - it allows the user to assign a parametric cross-section to a member. Valid values for this type of parameter are all entries in the Profile Library. To limit the number of cross-sections that are selected, user-defined sets with a limited number of cross-sections can be created in a quick and easy way.
User Blocks is a standard functionality in SCIA Engineer that allows for common or repeatable structural assemblies to be stored and reused in future models. Continuous beams, trusses, 2D/3D frames, etc. are examples of structures that are stored as User Blocks - these can be assigned cross-sections, supports, loads, connections and saved.
In combination with User Blocks, parametric modelling allows users to prepare parametric structures that can be inserted in any project as a sub-structure taken from the User Block Library. In this way, many types of structures are modelled much faster as one never needs to model from scratch.
When used in combination with the Project Template functionality of the Productivity Toolbox, the module allows users to create parametric projects with predefined geometry, material sets, loads, combinations and calculation report.
The obtained models are effectively simple programs for e.g. the calculation of continuous beams, simple frames, and other standard structures. In this way, design calculations can be performed, and documentation be prepared in a matter of minutes in the case of standardised structures.
As the final geometry and status of a model is not known in advance for parametric projects, Boolean operators add flexibility to the model definition techniques. For example, loads can be defined to only act in case certain conditions are fulfilled, addition bracing can be added only if the number of spans is high enough to require it, etc.
Parametric User Blocks may contain modular elements, e.g. continuous beams and frames where the number of spans is defined by the end-user.
When well prepared, parametric modelling may effectively be used for:
Required modules: